CTR - Area Control

RVSM & Level Allocation

Cruising levels by direction, RVSM airspace, step climbs and descents planned from cruise.

Lesson 2 of 4 4 min read 8 sections Updated Nov 9, 2026

Levels are the area controller's most important tool. Aircraft at different levels are separated no matter where they are, so a good level plan prevents most conflicts before they start. This lesson covers how cruising levels are assigned and how RVSM changed the upper airspace.

1. The semicircular rule

Cruising levels depend on the aircraft's magnetic track, so that opposite-direction traffic is always 1,000 ft apart:

Magnetic trackIFR levels up to FL410
000° – 179° (eastbound)Odd: FL70, 90 … 290, 310, 330, 350, 370, 390, 410
180° – 359° (westbound)Even: FL80, 100 … 280, 300, 320, 340, 360, 380, 400

Above FL410 the levels are 2,000 ft apart: eastbound FL450, 490…; westbound FL430, 470, 510…. Some FIRs use a different split (e.g. a north/south rule) – check the AIP.

2. RVSM

Reduced Vertical Separation Minimum allows 1,000 ft separation between FL290 and FL410, instead of the old 2,000 ft. It doubled the number of usable levels in the busy upper airspace. Rules:

  • Only aircraft approved for RVSM ("W" in the flight plan) may fly between FL290 and FL410 with 1,000 ft separation.
  • A non-approved aircraft must be separated by 2,000 ft from all others in that band (or kept below FL290).
  • If an aircraft loses RVSM capability in flight (autopilot or altimeter failure, severe turbulence), the pilot reports "unable RVSM due …" and you apply 2,000 ft or move it out of RVSM levels.

3. Assigning cruising levels

  • Give the flight-planned level when possible; it was chosen for performance and fuel.
  • If it's not available, offer the nearest correct level for the direction and an expectation: "Levant two one eight, climb flight level three four zero, expect flight level three eight zero in fifteen minutes."
  • Aircraft on crossing airways at the same level are your typical conflict: plan different levels early.
  • Same direction, same level, same airway: they need longitudinal spacing (radar 5 NM or more, larger when the follower is faster).

4. Step climbs

Long-haul aircraft start heavy and can't climb to their best level at once. As fuel burns off they request higher levels: "Amman Control, Levant two one eight, request flight level three eight zero." Approve when traffic allows: "climb flight level three eight zero." If not: "unable due traffic, expect higher in one zero minutes."

5. Level instructions

  • "Climb flight level three five zero." / "Descend flight level two four zero."
  • Rate: "climb at one thousand five hundred feet per minute or greater" when you need the level quickly.
  • Level by a point: "descend to reach flight level one two zero by ALPHA" (pilot chooses the top of descent).
  • "When ready": "descend flight level one eight zero when ready" lets the pilot start down at their best point.
  • Always check the readback of every level – level busts are among the most common causes of losses of separation.

6. Transition altitude and level

Below the transition altitude aircraft fly altitudes on QNH; above the transition level they fly flight levels on 1013 hPa. In Jordan the transition altitude is 13,000 ft and the transition level is FL150: aircraft climbing set 1013 hPa passing 13,000 ft, and aircraft descending set the QNH passing FL150. Other countries use different values – check each AIP. When you descend an aircraft below the transition level, give the QNH: "descend to eight tousand feet, QNH one zero one five."

Controlling it at Levant

Most Levant airliners flight-plan in RVSM levels between FL300 and FL400. With the Levant region's mix of north–south traffic (Gulf to Europe) and east–west traffic (Iraq to the Mediterranean), crossing conflicts are common – solve them with levels first.

Check yourself

  1. Magnetic track 270°. Choose an RVSM level near FL350. FL340 or FL360 (even, westbound).
  2. What does RVSM allow, and where? 1,000 ft separation between FL290 and FL410 for approved aircraft.
  3. A pilot reports "unable RVSM". What separation do you now apply? 2,000 ft in the RVSM band (or move it out).
  4. What is the difference between "descend FL180 when ready" and "descend FL180"? "When ready": the pilot chooses when to start; without it, start now.

Simulation training material based on ICAO Annex 2 and Doc 4444. Transition altitudes and level rules vary by state: check the AIP and IVAO division procedures.