TWR - Aerodrome Control

ATC Fundamentals

What air traffic control does: airspace, ATC units and positions, flight rules and the services controllers give.

Lesson 1 of 5 4 min read 8 sections Updated Nov 9, 2026

Air traffic control exists for three reasons: to prevent collisions between aircraft (and with obstacles on the ground), to keep traffic moving in an orderly and efficient way, and to give pilots the information they need. Everything a controller says serves one of those goals. This first lesson gives you the map: who controls what, where, and how.

1. The services ATC provides

ICAO (Annex 11) groups air traffic services into three families:

  • Air traffic control service: clearances and instructions that keep aircraft separated. Given by aerodrome control (Tower), approach control and area control (Centre).
  • Flight information service (FIS): weather, traffic and other information useful for the flight, without separating anyone.
  • Alerting service: telling search and rescue when an aircraft needs help or has gone missing.

A clearance is permission to proceed under specified conditions ("cleared to land", "cleared to Beirut"). An instruction is a directive ("turn left heading 090", "hold short of runway 26R"). Pilots read back both, and you must check every readback.

2. The ATC positions

From the gate to the cruise, a flight is passed along a chain of controllers. On IVAO the same positions are used, with the station suffix in the callsign (e.g. OJAI_TWR):

PositionSuffixResponsible for
Clearance DeliveryDELIFR route clearances before start-up
GroundGNDPushback and taxiing on the apron and taxiways
TowerTWRThe runways and the control zone (CTR): take-off, landing, VFR circuit
Approach / DepartureAPP / DEPThe terminal area (TMA) around one or more airports, usually by radar
Area control (Centre)CTREn-route airspace and the airways, sector by sector
Flight informationFSSInformation service in uncontrolled airspace or a whole FIR

Top-down rule: when a lower position is closed, the next one up covers it. If only Amman Approach is online, the approach controller also gives clearances, taxi and take-off at Queen Alia (OJAI). A Centre controller may cover the whole FIR down to the ground.

3. Airspace you control

  • Control zone (CTR): controlled airspace from the surface around an airport, owned by Tower.
  • Terminal control area (TMA): a larger block above and around one or more CTRs, owned by Approach.
  • Airways and upper areas: controlled corridors and blocks between terminals, owned by Centre.
  • FIR (Flight Information Region): the whole area of one country's service, e.g. Amman FIR (OJAC), Damascus FIR (OSTT), Beirut FIR (OLBB), Baghdad FIR (ORBB).

Each block has an airspace class (A to G). The class decides which flights need a clearance and whom you separate from whom – revise the table in the PPL Air Law lesson.

4. Flight rules: IFR and VFR

  • IFR flights fly by instruments, on a flight plan, and in controlled airspace are always separated from other IFR traffic.
  • VFR flights fly by looking outside, must stay in visual meteorological conditions and are responsible for seeing and avoiding others. In class C and D you give them clearances and traffic information.
  • Special VFR: a VFR flight in a control zone below the VFR minima, allowed by Tower with extra separation.

5. The tools on your screen

On IVAO you control with Aurora: a radar scope with sector files (runways, taxiways, airways, fixes), the flight strips, the flight plans and your radio. Each aircraft shows a label with callsign, level, ground speed and squawk. Learn to keep your scope tidy: the right sector file, the right range and only the labels you need.

6. A controller's mindset

  • Safety first, then order, then efficiency. A delay is always better than a doubt.
  • Plan ahead. Look at what each aircraft will do in the next 2–5 minutes, not only now.
  • Be brief and clear. One message, one idea, standard words. A busy frequency has no room for chat.
  • Never assume. If a readback is wrong or unclear, correct it ("negative, …").

Controlling it at Levant

Levant pilots fly on IVAO across Jordan, Syria, Lebanon and Iraq. When you open a Levant airport such as OJAI, OLBA, OSDI or ORBI, you are the person who turns a busy group flight into a smooth one. Start with Delivery or Ground at a quiet hour, follow the IVAO division's local procedures, and move up the positions as you gain confidence.

Check yourself

  1. Name the three types of air traffic services. ATC service, flight information service, alerting service.
  2. Only OJAI_APP is online. Who gives you taxi and take-off clearance? The approach controller (top-down).
  3. What is the difference between a clearance and an instruction? A clearance authorises; an instruction directs. Both are read back.
  4. Which unit owns the airspace from the surface around an airport? Tower, in its control zone (CTR).

Simulation training material based on ICAO Annex 11 and PANS-ATM (Doc 4444). Frequencies, SIDs and procedures in the ATC lessons are examples: always use the current IVAO division procedures and charts.