TWR - Aerodrome Control

Clearance Delivery

Giving IFR and VFR departure clearances: route, SID, initial level, squawk and frequency.

Lesson 3 of 5 4 min read 8 sections Updated Nov 9, 2026

Clearance Delivery (DEL) is the first controller most IFR pilots talk to. Before engines start, you give each departing flight its route clearance: where it may go, how it leaves the airport, the level it climbs to and the squawk that identifies it on radar. A good clearance makes everything after it easier for Ground, Tower and Approach.

1. Before the pilot calls

  • Check the flight plan: departure, destination, route, cruising level, aircraft type and equipment. Look for errors: a route that doesn't connect to a SID, a wrong level for the direction, a type that doesn't match the callsign.
  • Know the runway in use and the SIDs that go with it. The SID is chosen from the first waypoint of the route.
  • Know the initial climb level of each SID (often on the chart) and the departure frequency.
  • Assign a squawk from your airport's code range (Aurora can assign one automatically).

2. The IFR clearance: CRAFT

Remember the content with CRAFT:

  • Clearance limit – usually the destination: "cleared to Beirut".
  • Route – the SID and/or the flight-planned route: "via the LOSAR one charlie departure, then flight planned route".
  • Altitude – the initial climb: "climb flight level one three zero" (or "initial climb as per SID").
  • Frequency – departure frequency if not on the chart: "departure frequency one two zero decimal one".
  • Transponder – "squawk four two one five".

Example (all names and frequencies illustrative):

Pilot: "Queen Alia Delivery, Levant two one eight, stand one four, information Bravo, request IFR clearance to Beirut."
DEL: "Levant two one eight, cleared to Beirut via LOSAR one charlie departure, flight planned route, climb flight level one three zero, squawk four two one five."
Pilot: "Cleared to Beirut via LOSAR one charlie, flight planned route, climb flight level one three zero, squawk four two one five, Levant two one eight."
DEL: "Levant two one eight, readback correct, contact Queen Alia Ground one two one decimal niner when ready for push and start."

3. When the flight plan is wrong

  • Wrong level for the direction: give the correct one – "flight planned level not available, climb flight level one three zero, expect flight level three six zero ten minutes after departure".
  • Route doesn't connect to a SID: give a SID that does, or a radar vectors departure if Approach agrees.
  • Unknown or missing flight plan: ask the pilot to file one, or take the details by radio and create it.
  • When the clearance differs a lot from the plan, say so first: "Levant two one eight, I have an amended clearance, advise ready to copy."

4. VFR departures

VFR flights get a simpler clearance: the route out of the control zone, the exit point, an altitude restriction and the squawk.

"Levant two zero five, cleared to leave the control zone via November, VFR, not above two tousand five hundred feet, squawk seven zero four one."

5. Departure information (ATIS)

The ATIS is a recorded broadcast with the runway in use, weather, QNH and transition level (in Jordan FL150, with a transition altitude of 13,000 ft), labelled with a letter (Alfa, Bravo…). Ask pilots to confirm they have it: "confirm information Bravo". If the ATIS letter changes, tell them the new information.

6. Start-up and departure flow

At busy times, Delivery helps the flow. Give clearances early, note on the strip which aircraft is ready, and if departures are delayed tell pilots the expected start-up time so they don't burn fuel waiting at the gate. On IVAO events with many Levant aircraft at OJAI, a calm Delivery controller who issues clearances in order is the key to an on-time event.

Controlling it at Levant

Levant pilots plan with SimBrief and file IVAO flight plans with RMK/IVAOVA/LVT. When a Levant flight number shows "Levant two one eight" in telephony, the flight is a LVT open flight – it may use any aircraft type, so always check the type on the plan before choosing the SID and initial level.

Check yourself

  1. What does CRAFT stand for? Clearance limit, Route, Altitude, Frequency, Transponder.
  2. A pilot files FL370 eastbound on a route where your sector rules say odd levels eastbound in RVSM – is FL370 fine? Yes: FL370 is an odd level, correct eastbound.
  3. How do you start an amended clearance? "(Callsign), I have an amended clearance, advise ready to copy."
  4. What three things does a VFR exit clearance usually contain? Exit route/point, altitude restriction, squawk.

Simulation training material. LOSAR 1C (SID), MUNRA 1G (STAR) and the ILS Z runway 26R are real Queen Alia (OJAI) procedures; frequencies, other fixes and levels are examples. Always use the current charts and IVAO division procedures.