APP - Approach Control

Instrument Approaches

Clearing ILS, RNP and VOR approaches, intercepting final and handling missed approaches.

Lesson 5 of 5 4 min read 8 sections Updated Nov 9, 2026

The last part of every arrival is the instrument approach: a published path that brings the aircraft from the en-route or vectoring altitude down to a point from which the pilot can see the runway and land. As an approach controller you choose the approach, clear the aircraft for it, and hand it over to Tower at the right moment.

1. Types of approach

ApproachGuidanceTypical minimum
ILS (Cat I)Localiser (lateral) and glide slope (vertical) from ground beams200 ft decision height, 550 m RVR
ILS Cat II / IIISame, with certified aircraft and crew100 ft down to zero
RNP (RNAV GNSS)GPS lateral; LNAV/VNAV or LPV vertical250–400 ft (LPV close to ILS)
VOR / NDBLateral only, step-down altitudes400–600 ft minimum descent altitude
VisualThe pilot flies by sightRunway or preceding traffic in sight

Choose the most precise approach available for the runway in use, unless the pilot requests another or the weather allows a visual.

2. Clearing an approach

  • From vectors: give a final heading to intercept and the clearance together: "turn left heading two eight zero, cleared ILS Z approach runway two six right."
  • From the IAF (no vectors): "cleared RNP approach runway two six left via ALPHA."
  • Give an altitude to maintain until established: "maintain four tousand feet until established on the localiser."
  • Make sure the aircraft has the current QNH and the approach in use is on the ATIS.

3. Handover to Tower

Transfer the aircraft once it is established on final and separated from everything else – typically around 8–10 NM final: "Levant two one eight, contact Queen Alia Tower one one eight decimal one." From there, Tower owns the landing. If spacing gets too tight after the handover, coordinate with Tower immediately.

4. Missed approaches

Every approach has a published missed approach procedure – a climb straight ahead or with a turn to a safe altitude and a holding fix. A pilot goes around when they cannot see the runway at the minimum, the approach is unstable, or Tower tells them to.

  • Tower tells you at once: "Levant two one eight going around."
  • The aircraft follows the published missed approach unless you give something else. Protect that airspace: departures from the same runway may be in the way.
  • Then ask the pilot's intentions and re-sequence: "Levant two one eight, climb four tousand feet, turn right heading three six zero, vectors for another ILS, say reason for go-around."

5. Low visibility

When visibility drops (fog in the Jordan Valley mornings or at Baghdad in winter), Low Visibility Procedures (LVP) apply: larger spacing on final, protection of the ILS critical areas (no aircraft on taxiways near the antennas), Cat II/III approaches only for approved crews. Tell pilots the RVR: "RVR runway two six right four hundred metres."

6. Visual approaches

In good weather, visual approaches save time: "report runway in sight" – "runway in sight" – "cleared visual approach runway two six right." You still separate the aircraft from other IFR traffic until it lands, unless visual separation has been given.

Controlling it at Levant

Most Levant pilots fly with simulator navigation data that supports both ILS and RNP. Ask on first contact which approach they expect from the ATIS, and if a pilot struggles on the ILS, consider offering vectors with a longer final to give them more time.

Check yourself

  1. What does an ILS give that a VOR approach does not? Vertical guidance (glide slope) – it is a precision approach.
  2. Which altitude instruction goes with an approach clearance from vectors? "Maintain (altitude) until established."
  3. An aircraft goes around. What does it fly if you say nothing? The published missed approach procedure.
  4. Name one ATC measure in low visibility. Larger spacing, protecting ILS critical areas, Cat II/III only for approved crews, giving RVR.

Simulation training material based on ICAO PANS-OPS and PANS-ATM. Minima and frequencies are typical examples.